Inspecting The Package Contents; Selecting The Location For Installation - Power One AURORA PVI-3.8-I-OUTD Manuel D'utilisation Et D'installation

Installation and operating manual
(PVI-3.8/4.6-I-OUTD Rev.: 1.5)
3.2

Inspecting the package contents

AURORA Inverter
Bag containing:
4 screws 6.3x70, 4 SX10 anchors, Torx20
screwdriver, 1 screw 6x10, 5 washers d. 18, 2
counterparts for signal connectors (3 poles), 2
counterparts for signal connectors (8 poles)
Bracket for wall mounting
Copies of this manual
Certificate of warranty
CD-ROM with communication software
3.3

Selecting the location for installation

The inverter must be installed in a location chosen according to the following
considerations:
The inverter must be placed at a height from ground level, so that the display and
status LEDs can be read easily.
Choose a location which is protected from direct sunlight and is well-ventilated.
Avoid locations where air is unable to circulate freely around the unit.
Leave enough room around the unit to allow for easy installation and removal from
the mounting surface.
Hardware and software maintenance is carried out through the cover on the front of
the inverter. It is thus necessary to have easy access to this side, if you do not wish
to remove the unit from its mounting surface.
The figure below indicates minimum clearances that must be maintained around
the inverter:
Description
Page 20 of 95
Quantity (No.)
1
1
1
1
1
1