Power One AURORA PVI-3.8-I-OUTD Manuel D'utilisation Et D'installation page 77

Installation and operating manual
(PVI-3.8/4.6-I-OUTD Rev.: 1.5)
Enable / Disable
Compose message
Move the selection arrow using the UP and DOWN keys, press ENTER to navigate
the submenus or select the functions.
Once the personalized message has been enabled, you must compose the message
itself.
Upon selecting Compose Message you will be able to write the first line of the
message.
The maximum numbers of characters is 16. Pressing the Enter key 17 times will allow
you to move to the second line.
To write the message, use the display keys, following procedure below:
Use the ENTER key scroll from one position to the next (from left to right)
Use the ESC key to return to the previous position (from right to left)
Press the ESC key several times to return to previous menus, as described in
chapter 5.5.3
Use the UP key to scroll through the numbers, letters and symbols in
ascending order
Use the DOWN key to scroll through the numbers, letters and symbols in
descending order
Compose Message message
Message line 1:
- - - - - - - - - - - - - - - -
Enable Msg
Disable Msg
Message line 2:
- - - - - - - - - - - - - - - -
Page 76 of 95