Connection To The Ac Grid - Power One AURORA PVI-3.8-I-OUTD Manuel D'utilisation Et D'installation

Installation and operating manual
(PVI-3.8/4.6-I-OUTD Rev.: 1.5)
3.4.6

Connection to the AC grid

WARNING:
connection/disconnection procedure detailed in paragraph 3.4.1.
Step 1: Remove the front cover of the inverter as shown in section 0.
Step 2: Connect the AC cables from the external disconnector to the internal inverter
terminal box indicated by the serigraphy "GRID".
Step 3: Install the cable gland (supplied) onto the dedicated hole located on the bottom
of the inverter and use it to pass through the AC cables.
Step 4: Connect the 3 AC conductors to the inverter terminal box, following the
serigraphy.
- Terminal
symbol can also be used for connecting to the earth conductor)
- terminal 1 for Neutral N,
- terminal 2 Line L,
A
Before carrying
for protective earth PE (the screw located next to the
Fig. 12 - Terminal Block for connection to AC conductors
out any operation,
Page 34 of 95
follow the