System Configuration For Connection To The Lan Network (Ethernet Port) - Power One AURORA PVI-AEC-EVO Guide D'installation Rapide

I. System Configuration for connection to the LAN
Network (Ethernet Port)
The connection to the PC of PVI-AEC-EVO can be made through direct connection via Ethernet cable, or connecting
both devices to a local network LAN (via router,hub or switch).
In case of direct connection,it is enough to connect the two devices between them through a Ethernet cable and set
the network parameters of PVI-AEC-EVO and of the PC to make sure they are compatible between them.
Note: The IP address of the PC and the IP address of the PVI-AEC-EVO must belong to the same group but
they must not be identical
The subnet mask must be the same for both devices, for instance: 255.0.0.0
In case of connection to a pre-existing local network LAN,it is necessary to assign to PVI-AEC-EVO the network parameters
which have to be compatible with the local network to which the PVI-AEC-EVO is connected. Make reference to the
network administrator to obtain the correct parameters of the network.
CHANGE OF PC NETWORK PARAMETERS
In order to change pc network parameters, please select
Connections" : the new window will show the network connections; with the right button of your mouse click on
"Local Area Connection" and select
Windows XP
Select "Internet Protocol (TCP/IP)"
"Properties".
Monitoring System
,for instance:
PC IP ADDRESS: 20.200.200.
PVI-AEC-EVO IP ADDRESS:
"Properties" ;as shown in the following figure.
(or "Internet Protocol Version 4 (TCP/IPv4)"
14 - EN
1
20.200.200. 24
"Start" and then "Control Panel",
Windows 7/8
in Windows 7/8) and click on
click on "Network