Emerson Appleton Rigmaster Feuille D'instructions page 2

Applications/Intended Use
• Areas where flammable gases and vapors are present under conditions defined by the ratings below.
• Areas of low clearance, low ceiling heights, or where luminaire weights must be minimized.
• Non-hazardous locations where severe weather conditions, excessive moisture, dirt, dust, corrosive atmospheres, and high
ambient temperatures are encountered.
• Where flexible cord is used, it should be approved for extra hard, wet location usage and shall have a separate ground conductor.
• Luminaire is suitable for mounting height as per table-1 to meet 1 Foot-Candle requirement during emergency operation.
Duration Setting
90 Minutes
180 Minutes
Agency Ratings: (NEC/CEC)
• Class I, Division 2, Groups A, B, C, D
• Class II, Division 1, Groups E, F, G
• Class III
• Type 3R, 4 & 4X
• IP66
NOTES:
 Refer product nameplate, located on the housing body, for details.
Appleton • 1.800.621.1506 • www.appletonelec.com
Table 1: Suitable Mounting Height
Clear Lens
<18 ft
<14 ft
• Class I, Zone 2, Group IIC
• Zone 20
• Wet Locations
• Simultaneous Exposure
Diffused Lens
<16 ft
<13 ft
650610-000 Rev. 03 11/02/20 • Page 2 of 43