Floor Nozzle; Suction Tube - Cleanmaxx PC-U001 Mode D'emploi

EN
Handle

Floor Nozzle

The fl oor nozzle is required to clean fl oors.

Suction Tube

Combi or Upholstery Nozzle
To use the combi or upholstery nozzle, the suction hose must be connected to the handle
(see "Suction Hose", page 23).
1. Remove the suction tube from the device (see above).
2. Plug the suction tube as far as it will go into the combi or upholstery nozzle. Twist the
nozzle back and forth slightly as you do this.
• To detach a suction nozzle, pull it off.
• You can place one of the two nozzles onto the holder on the housing of the motor
unit for storage.
07517_de-en-fr-nl_A5_V1.indb 24 07517_de-en-fr-nl_A5_V1.indb 24
24
1. Remove the suction hose from the fl oor nozzle (see
"Floor Nozzle").
20
2. Push the end piece of the suction hose onto the suction
hose connection on the handle. It must engage.
• To remove the suction hose, press the release but-
ton (20) on the end piece of the suction hose and then
pull it off.
1. Hold the fl oor nozzle fi rmly and fl ip the contact connec-
tor (19) upwards until it engages.
2. Push the connecting socket on the bottom of the mo-
19
tor unit onto the contact connector. The motor unit must
engage.
• To remove it, secure the fl oor nozzle (e.g. with your
foot), press the release button below the motor unit and
pull the motor unit up and away at the same time.
• To clean fl oors, plug the suction tube into the opening at
the top end of the device. It must engage audibly.
• To remove the suction tube, fl ip the locking catch away
from the suction tube and pull the suction tube out.
29.04.2016 12:38:52 29.04.2016 12:38:52