Installation; Wall Mounting - Style 5-5S-7-7D-7E Ind-Imp-Fi+Dcf-Afnor-Dhf - Bodet Style 5 Notice D'installation Et De Mise En Service

II

– Installation

2.1 Wall mounting – Style 5-5S-7-7D-7E IND-IMP-FI+DCF-AFNOR-DHF
The visuals below refer to the Style 5 clock. However, the installation process shown also applies to
Styles 5S, 7, 7D and 7E. Refer to the Technical specifications on page 18 for clock dimensions.
1) Fix the wall bracket to the wall using the four Ø4 mm dowel screws supplied.
2) For cabled versions (AFNOR and IMP),
insert the power and synchronisation cables:
• From above: cut through the top of
casing u.
• From the rear: dedicated space v.
3) Attach the electronic board to the wall
bracket. Insert the lower part of the electronic
board into the back of the wall bracket then
push the upper part of the board in towards
the back of the bracket until it clicks w.
4) For electrical connections, refer to page 7.
5) Connect the power cable to the electronic
board using a plastic cable tie (mounting
hole provided in the electronic board).
6) Connect the ribbon from the LED modules
(clock casing) to the electronic board x.
7) Attach the clock to the wall bracket by
inserting the upper part of the clock into the
back of the bracket in the slots provided,
then press the clock in until it clicks.
Secure the clock to the bracket at the bottom,
using the mounting screw provided.
Ensure that the cables are not trapped
during this operation.
8) The clock may be subsequently detached from the bracket by lifting the lower part of the clock
outwards, then removing the upper part.
9) Remove the protective film from the front and clean the clock using an anti-static cloth.
All manuals and user guides at all-guides.com
w
EN
u
v
Back view
w
x
Right side
cutaway view
5