Jacuzzi sasha Utilisation & Entretien page 43

manual programme
activation
B
A C
■ Every programme can be interrupted at any time by pressing the key relative to the
programme itself.
It is also possible to switch from one programme to another, by first deactivating the
programme in progress. wait approximately three minutes until the draining and rinsing of
the steam generator has finished and then press the key relative to the desired programme.
■ The temperature value within the hammam room will be provided by the "thermometer"
symbol present on the display; the temperature value is provided in three stages, beginning with
the activation temperature which will increase (progressive). When the the final stage temperature
lights up, the ideal temperature relative to the selected programme, has been reached.
ATTENTION! The emerging steam has a temperature nearing 100 °C!
Do not rest legs on the steam outlet, keeping them at least 40 cm from the
outlet nozzles (dispenser).
■ Each programme has a predefined light colour (the shown symbol lights up); specifically
designed to heighten those feelings of well-being and relaxation that Sasha offers.
Refer to the Chapter "Cromodream® for more detailed information.
Brassware
Before using the manual functions, it is advisable to regulate the water temperature to the
desired value.
■ Rotate the knob (M) so that the reference notch aligns with the preselected value.
The knob is equipped with a safety stop that limits the temperature to 38 °C; to select
higher temperatures, press the button (P).
The maximum temperature of the mixed water must never exceed 45 °C!
■ Testing the water temperature:
- bring the diverter's ring nut (G) so that it aligns with the spout and turn the tap (R) so
that the water runs.
■ When the water has reached the desired temperature, rotate the ring nut (G) to the position:
- A: if you intend to use the spout.
- B: if you intend to use the shower head.
- C: if you intend to use the shower.
ù
Following each use, remember to close the tap (R) and position the diverter's ring nut so that
it aligns with the "spout" symbol.
In the instance where temperatures exceeding 38 °C have been selected, position the mixer
knob (M) before the safety stop.
43