Videotec MAXIMUS MPX 2 Serie Manuel D'instructions page 10

DANGER!
Emission of visible light or infrared.
Can be harmful for eyes. Pay attention to
the provided indications.
• Do not stare at the lamp when on. Can be harmful
for eyes.
• CAUTION! The infrared LED illuminator emits high-
intensity visible light. In compliance with standard
EN62471/IEC62471, the photobiological safety
assessment has classified the device in Risk Group
2, where it exceeds the values of the Exempt
Group. The risk linked to the observer depends on
how the product has been installed and is used.
For installation, follow the instructions in this
manual. Do not look directly at the illuminator
using optical lenses. Exposure hazard values
(EHV): 30.1s. Hazard distances (HD): 200mm.
• CAUTION! The white LED illuminator emits visible
high intensity light. In compliance with standard
EN62471/IEC62471, the photobiological safety
assessment has classified the device in Risk Group
2, where it exceeds the values of the Exempt
Group. The risk linked to the observer depends on
how the product has been installed and is used.
For installation, follow the instructions in this
manual. Do not look directly at the illuminator
using optical lenses. Exposure hazard values
(EHV): 33.3s. Hazard distances (HD): 200mm.
8
CAUTION!
Medium level hazard.
This operation is very important for the
system to function properly. Please read
the procedure described very carefully
and carry it out as instructed.
• Make sure that the installation complies with local
regulations and specifications.
• Make connections and tests in the laboratory
before carrying out installation on site.
• Check that the power supply socket and cable are
adequately dimensioned.
• Use suitable cables that can withstand the
operating temperatures.
• All disconnected cables must be electrically
isolated.
• The system can be installed only in a standard or
inverted position (ceiling mount).
• Make sure the product is to be secured to building
before operation.
• At start up the system makes some automatic
calibration movements: do not stand near the
device when it is powered.
• The manufacturer declines all liability for damage
to any of the apparatus mentioned in this
handbook, when resulting from tampering, use of
non-original spare parts, installation, maintenance
and repairs performed by non-authorised, non-
skilled personnel.
• For technical services, consult only and exclusively
authorized technicians.
• This product must only be repaired by suitably
trained personnel or under the supervision of
VIDEOTEC personnel in accordance with the
foreseen terms and conditions: IEC/EN60079-19.
• Only use original VIDEOTEC spare parts. Strictly
adhere to the maintenance instructions attached
to each replacement kit.
MNVCMPXHDC_2222_EN