Connection Compartment Closing - Videotec MAXIMUS MPX 2 Serie Manuel D'instructions

6.9 Connection compartment
closing
If you can't turn by hand the threaded
lid before the OR reaches the tube of the
connection compartment this means that
there are debris\dirt on the threads or that
the lid is misaligned. In this case there's
a serious danger of threads damaging.
Unscrew the lid and check the alignement
and/or clean the threads.
Never force the rotation of threaded lid
before the OR reaches the connection
compartment, otherwise thread damage
could occur.
If you suspect that any kind of thread
damaging has occurred, suspend the
installation. The device could be no longer
safe for the installation on a potentially
explosive atmosphere. In this case contact
VIDEOTEC technical support.
Before closing the cover, check the
integrity of the O-ring gasket. If the
gasket is damaged, replace it with the one
supplied (10.1.2 Replacing the gasket,
page 35).
Verify that there is no dirt or debris.
Lubricate the threads with grease compliant with
IEC/EN60079-14 to facilitate screwing the cover on.
Arrange the cables so that there is no interference
when closing the threaded lid of the connection
compartment.
Screw by hand the threaded lid of the connection
compartment till the OR gasket reaches the tube.
Fig. 20
MNVCMPXHDC_2222_EN
Fig. 21
Use a 30mm wrench for closing the threaded lid of
the connection compartment. Make sure that there's
no gap between the threaded cap and the junction
box tube after tightening the cap.
Fig. 22
Fixing the safety grub screw is necessary to
complete product closure, to prevent unwanted
unscrewing of the threaded plug.
Fig. 23
33