Leg Length Discrepancy (I); Contour Cushion (I); Backrest Webbing (I) - Breezy NUAGE PL Notice D'utilisation

20 Settings (by a professional)

5.22 Leg length discrepancy (I)

1. Move one of the seat shells forwards. To do
so, loosen the armrestholder, slide it in the
rail towards the front of the seat and fasten
again.
2. Tension an adjustable strap from slotted
hole (G) to slotted hole (I). At (I) remove the
sliding buckle.
Note!
Step 1 is not possible in combination with
seating systems other than Sedeo Pro /
Sedeo Original.

5.23 Contour cushion (I)

Optionally the front straps can be replaced with
a contour cushion.
1. Remove the front webbing straps (B).
2. Put the cushion segments together attaching
with the velcro strap to the bottom side and
place the contour cushion (C) on the seat.
3. Loop webbing straps (B) over the top of the
cushion through slotted hole (I) and attach
on the outside of the seat shells with velcro.
4. Place a webbing strap (B) against the front
of the contour cushion and attach directly on
the outside of the seat shells with velcro.
Caution!
Do not put much tension on the straps (B)
that hold the contour cushion in place.

5.24 Backrest webbing (I)

The 6 adjustable straps (Z) and 1 simple
webbing strap (B) (Nuage PLS Active XS: five
adjustable straps) enable to follow the contours
of the back, create a lumbal support and give
further extra support where needed.
1. Place a webbing strap (B) in the upper
slotted holes (K).
2. Tension strap and fasten the velcro ends.
3. Place adjustable webbing straps (Z) in
slotted holes (L), (M) and / or if required over
I
I
2
B
4
M
XS
N
N
Nuage
2
G
1
C
B
3
K
L
M
L
36
37
I
38