Seat And Backrest Shells (I); Seat Webbing (I); Pelvic Obliquity (I) - Breezy NUAGE PL Notice D'utilisation

Nuage

5.19 Seat and backrest shells (I)

The straps are looped through slotted holes in
adjustable plywood seat shells (D) and backrest
shells (E).
Warning!
Tension the straps sufficiently to prevent
bottoming-out.

5.20 Seat webbing (I)

The 4 webbing straps (B) in the front and the
4 adjustable straps (Z) in the back enable to
follow the contours of buttocks and upper legs
while in the mean time providing support where
needed for an optimal seating position and
stability.
2. Place the adjustable straps (Z) in slotted
holes (F), (G) and / or if required over the
edge (H).
3. Tension adjustable straps and fasten the
velcro ends.
4. Tension further with the sliding buckles.
5. Place the simple straps (B) in slotted hole
(I).
6. Tension to approx. 110% of the length and
fasten the velcro ends.
Warning!
Always check for bottoming-out. If needed
adjust the strap tension.

5.21 Pelvic obliquity (I)

1. Tension the adjustable straps in slotted
holes (F) and (G) or if required in slotted
hole (G) and over edge (H).
2. Use the sliding buckles and move the velcro
ends to create a different (asymmetrical)
support left and right.
Settings (by a professional)
E
D
2
19
33
34
H
G
F
I
35
H
1
G
F