Leg Length Discrepancy (Ii); Backrest Webbing (Ii); Dorsal Obliquity (Ii) - Breezy NUAGE PL Notice D'utilisation

14 Settings (by a professional)

5.6 Leg length discrepancy (II)

1. Move one of the seat shells (D1) forwards.
To do so, loosen the armrestholder and
webbing straps (B) , slide it in the rail towards
the front of the seat and fasten again.
2. On (D1) shift the position of the webbing
straps (B) one slot position to the back.
Tension the webbing straps (B) in slotted
holes (F1 to F5) or if required over edge (G).
3. Reposition (C) and the front webbings straps
(B).
Note!
Step 1 is not possible in combination with
seating systems other than Sedeo Pro /
Sedeo Original.

5.7 Backrest webbing (II)

The webbing straps (B) enable to follow the
contours of the back, create a lumbal support
and give further extra support where needed.
1. Identify the set of slotted holes best suited to
accomodate the user (positions J1 to J3).
2. On left and right backrest shell (E) loop
each strap (B) through a slotted hole (J) or if
required over the edge (G).
3. Attach the velcro strap ends to the velcro
outer shell surface.
4. Put tension on the webbing straps by
stretching them to about 110% of their
length.
Warning!
Always check for bottoming-out. If needed
change strap position and/or strap tension.

5.8 Dorsal obliquity (II)

1. Create an asymmetrical support by choosing
different slottted holes (J1 to J3) left and
right.
2. Tension the webbing straps (B) in slotted
holes (J1 to J3) or if required over edge (G).
D1
B
F
2
1
G
J1- J3
G
J1- J3
Nuage
15
D2
C
3
16
B
17