Operating Mode; Analog Operating Mode - Mettler Toledo InPro 8300 RAMS Manuel D'utilisation

InPro 8300 RAMS Optical Product Monitor
Relative humidity in %, measured in the electronics housing on the connection side near the window;
Serial number
Firmware
Processor
Digital or analog operating mode
mA output
The connection status is displayed for all read and write operations. When a transmission error
occurs when writing or reading data, this is indicated in the text field under Connection status.
Change-over
Here you can toggle between BASIC and CALI or between BASIC and COMBINE (not possible on
InPro 8300 RAMS BASIC).
Calibration 1/2/3
This takes you to the InPro 8300 RAMS calibration mode. See section 6.
Correct
A new window opens where the InPro 8300 RAMS calibration can be adjusted to the results obtained
in the plant laboratory (function not included on InPro 8300 RAMS BASIC).

5.4 Operating Mode

The InPro 8300 RAMS has 2 operating modes:
• Digital
• Analog

5.4.1 Analog operating mode

Use
• Preferably when different InPro 8300 RAMS parameters are to be monitored by an external control
system
• For signalling phase interfaces. Limit values are generated by the plant control system.
• Units of the InPro 8300 RAMS CALI or COMBINE type generally operate in the analog mode.
© 04/09 Mettler-Toledo AG, Greifensee
Printed in Switzerland
the colour of the display window changes and an alarm is triggered if the values
exceed 15 %.
of the InPro 8300 RAMS
informs about the release status of the internal InPro 8300 RAMS software.
shows the software installed in the InPro 8300 RAMS:
00.00 = BASIC – used for phase separation, as limit value switch for turbidity or
colour and for product identification.
00.41 = CALI – for the continuous measurement of turbidity and/or colour
00.47 = COMBINE – for the continuous measurement of turbidity (also fine
turbidity) and/or colour, used in special applications.
connected to which parameter
InPro 8300 RAMS Optical Product Monitor
25
52 801 115