Setup For Working With The Sample Pump; Activate The Sample Pump Mode; Install The Filling Tube; Activate And Deactivate The Rfid Reader (Densitopro Only) - Mettler Toledo Densito Guide De L'utilisateur

4.4 Setup for working with the sample pump

4.4.1 Activate the sample pump mode

1 Press the Menu key.
2 Navigate to Settings > Measurement > Sampling.
ð The Sampling window opens.
3 Navigate to Sample pump.
4 Press the OK key.
5 Navigate back to the home screen.
ð The icon
is displayed in the sampling ribbon.

4.4.2 Install the filling tube

§
The filling tube (tube (1), connector (2) and washer (3))
is assembled.
§
The locking screw (2) is installed and tight.
− Screw the connector (1) of the filling tube into the
opening (3) and tighten it.

4.5 Activate and deactivate the RFID reader (DensitoPro only)

1 Press the Menu key.
2 Navigate to Settings > RFID / Barcode > Type.
ð The Type window opens.
3 To activate the RFID reader, navigate to RFID.
4 To deactivate the RFID reader, navigate to None.
5 Press the OK key.

4.6 Activate and deactivate the barcode reader (DensitoPro only)

1 Press the Menu key.
2 Navigate to Settings > RFID / Barcode > Type.
ð The Type window opens.
3 To activate the barcode reader, navigate to Barcode.
4 To deactivate the barcode reader, navigate to None.
5 Press the OK key.
Handheld Density Meter
1 2 3
1 2
3
9