Sissel Hang UP PRO Manuel D'utilisation page 35

Step 7
Install the Lock Handle P Bar (34) onto the Lock Mechanism (33) and secure with one Bolt (81). Tighten
Bolt (81) with the Multi Hex Tool with Phillips Screwdriver provided.
Step 8
Slide two Heel Holder Brackets (7) and Rubber Heel Holders (31) onto both ends of the Rear Rod (9)
until the lock teeth are wedged into the slots in the Rear Rod (9), as shown in detailed drawing below.
Slide Front Heel Holders (5) onto Front Rod (11).
Turn Rod Caps (26) clockwise onto the Front Rod (11).
AH 07 V4
NOTE: Make sure the lock teeth are wedged into the
slots in the Rear Rod (9) to lock the Heel Holder
Brackets (7) and Rubber Heel Holders (31) in place
before use.
Hardware:
(81) Bolt
1 PC
35 / 108