Installing The Control Panel Remotely; Countertop Cutout Dimensions - Hatco FTB Série Manuel D'installation Et D'utilisation

English

Installing the Control Panel Remotely

Use the following procedure to install the control panel
remotely.
WARNING
Control panel must be mounted in a vertical surface.
Mounting control panel in a horizontal surface may result
in the collection of liquids and lead to electric shock.
1. Remove the four trim cover screws from the control panel,
and remove the trim cover.
2. Position the control panel into the cutout opening through
the backside.
3. Fasten the control panel to the vertical surface using four
screws (not supplied).
4. Reinstall the trim cover on the control panel and secure in
position using the four trim cover screws. Seal the trim
cover to the mounting surface with silicone adhesive.

Countertop Cutout Dimensions

Width
Model (A)
19-7/16" to 20-1/8"
FTB-3/4
(494 to 511 mm)
19-7/16" to 20-1/8"
FTB-1
(494 to 511 mm)
37-3/8" to 38"
FTB-2
(949 to 965 mm)
55-3/8" to 56"
FTB-3
(1407 to 1422 mm)
Form No. FTBm-1015
Depth
(B)
16-1/2" to 17-1/16"
(419 to 433 mm)
27-7/16" to 28"
(697 to 711 mm)
27-5/16" to 28"
(694 to 711 mm)
27-5/16" to 28"
(694 to 711 mm)
FTB-3
A
FTB and FTB-S Series Countertop Cutout Dimensions.
(189 mm)
Control Panel Cutout Dimensions
NOTE: Make sure the width of the control panel cutout does
not exceed the above dimension .
Model
53-5/16" to 54"
FTB-S2
(1354 to 1372 mm)
79-3/16" to 79-7/8"
FTB-S3
(2011 to 2029 mm)
B
9
INSTALLATION
1-1/16"
(27 mm)
5-5/8"
(143 mm) 3-1/2"
(89 mm)
7-7/16"
7-3/4"
(196 mm)
Width Depth
(A)
19-7/16" to 20-1/8"
(494 to 511 mm)
19-7/16" to 20-1/8"
(494 to 511 mm)
FTB-S2
A
(B)
B