Basic Operations; Before Operation - JVC XV-FA900BK Manuel D'instructions

Basic operations

In the following description, we assume that the buttons on the remote control unit are mainly used, however, you may
use the corresponding buttons on the front panel if available.
NOTE
Make sure that the TV - DVD switch on the remote control unit is set to "DVD" when using the 5/∞/
2/3 and numeric buttons for controlling the unit.
TV DVD

Before operation

Turning on/off the unit
Press DVD STANDBY/ON
When the unit turns on, the STANDBY/ON indicator on the front panel, which illuminates in red during standby, lights in
green and each DISC indicator (1 to 7) shows the current status of whether a disc is set or not in the corresponding disc
tray.
OPEN/ DISC
CLOSE SELECT
TV1
1
TV4
4
TV7
7
TV-/--
10
RETURN PAGE
CH
+
VOL-
ENTER
CH
-
PREVIOUS
CLEAR SELECT
SLOW-
REPEAT SUB TITLE
DIGEST ANGLE
3D
PHONIC
RM-SXV016J
REMOTE CONTROL
• The first time you turn on the unit after connecting the power cord, the DISC 1 to 7 indicators are illuminated until the unit detects
that no disc is set in the corresponding disc tray. Once detecting the status, the unit memorizes it unless you unplug the power
cord, so the DISC 1 to 7 indicators show the status of corresponding disc trays correctly.
• You can turn on the unit by pressing the
pressing this button while the power is on.
• When any disc is on the disc tray, you can turn on the unit using the DISC 1 to 7 buttons corresponding to the loaded disc number.
The behavior of the unit after pressing these buttons is the same as pressing them while the power is on.
• You can turn on the unit by pressing the 0 OPEN/CLOSE button on the front panel. In this case, the disc tray carousel opens.
The opening display shown right appears on the TV screen.
The following message may appear at the bottom of the opening display
depending on the condition.
• NOW READING:The unit is reading the disc information.
• REGION CODE ERROR!:
• OPEN:
• CLOSE:
• NO DISC:
• RESUME STOP:
NOTE
• Even if you press DVD STANDBY/ON
the unit is not disconnected from the AC power source as long as it is connected to the wall outlet. This state is called the
standby mode. In this state, the unit consumes a very small amount of power.
14
on the remote control unit or press STANDBY/ON
TV DVD
STANDBY/ON
TV DVD
DVD
TV2 TV3
2 3 STANDBY/ON
TV5 TV6
5 6
TV8 TV9
8 9
TV0 MUTING
0 +10
TITLE/ TV/VIDEO
GROUP CANCEL
VOL+
NEXT
STROBE
SLOW+
AUDIO VFP
fs/Rate PROGRESSIVE
SCAN
ZOOM
AMP VOL
3
button. In this case, the behavior of the unit after pressing the
The region code of the DVD VIDEO disc does not
match the unit. The disc cannot be played back.
The disc tray carousel is opening.
The disc tray carousel is closing.
No disc is loaded.
The resume mode is set to "DISC RESUME."
on the remote control unit or STANDBY/ON
STANDBY/ON indicator
STANDBY/ON
STANDBY/ON
STANDBY/ON
on the front panel.
DISC 1 DISC 2 DISC 3 DISC 4 DISC 5 DISC 6 DISC 7
DVD AUDIO/DVD VIDEO/SUPER VCD/VCD/CD PLAYER
DVD AUDIO PROGRESSIVE
3
button is the same as
NOW READING
Message area
on the front panel to turn off the unit,
EX