Basic Operations; Turning On/Off The Player; Initial Setup - JVC XV-N50BK Manuel D'instructions

Basic operations

STANDBY indicator
OPEN/CLOSE
ENTER
CHOICE
7
NOTE
Make sure that the TV - DVD switch on the
remote control unit is set to "DVD" when
TV DVD
using the 5/∞/2/3 and numeric buttons
for controlling the player.
About invalid operation icon
When you press a button, and if the player does not accept its
operation, appears on your TV screen. Operations are
occasionally unacceptable even if
Note that some operations may not be accepted. For example,
some discs may not allow rapid advance/reverse or slow-
motion playback.

Turning on/off the player

Press DVD STANDBY/ON
control unit or press
The STANDBY/ON indicator on the front panel, which lights
in red during standby, lights in green.
The left and right sides of the display window are illuminated.
The opening display appears on the TV screen, and the following
messages may appear at the bottom of the opening display.
NOW READING
Message area
• NOW READING (The player is reading the disc information.)
• REGION CODE ERROR! (The region code of the DVD VIDEO
disc does not match the player. The disc cannot be played
back.)
• OPEN
8
0 7 3
DVD STANDBY/
ON
5/∞/2/3
3
DIMMER
is not displayed.
on the remote
on the front panel.
• CLOSE
• NO DISC
NOTE
Even if you turn off the player, the player is not disconnected from
the AC power source as long as it is connected to the wall outlet.
This state is called standby mode. In this state, the player
consumes a very small amount of power.

Initial setup

When you turn on the player for the first time after purchase, the
following message appears on the TV screen.
EXECUTE DVD PLAYER SETUP? - BASIC PICTURE/AUDIO
SETTING
YES - PRESS ENTER NO - CANCEL
You can set the display language, TV monitor type and digital
output before using the player, by following the procedure below.
1
Press ENTER.
The first page of the DVD PLAYER SET UP display appears.
The pull-down menu of the [ON SCREEN LANGUAGE] is
already open.
DVD PLAYER SET UP
MENU LANGUAGE
AUDIO LANGUAGE
SUBTITLE
ON SCREEN LANGUAGE
SELECT USE 5∞23 TO SELECT, USE ENTER TO CONFIRM
ENTER
ON SCREEN LANGUAGE options
2
Press 5/∞ to select the desired language.
You can select the on-screen language for the preference
displays, etc. from among ENGLISH, SPANISH and
FRENCH.
3
Press ENTER.
The second page is shown, in which the pull-down menu of
the [MONITOR TYPE] is already open.
DVD PLAYER SET UP
MONITOR TYPE
PICTURE SOURCE
SCREEN SAVER
MP3&WMA/JPEG
SELECT USE 5∞23 TO SELECT, USE ENTER TO CONFIRM
ENTER
MONITOR TYPE options
4
Press 5/∞ to select the desired monitor type.
For a normal (conventional) TV, select [4:3 LB] or [4:3 PS].
For a wide-screen TV, select [16:9 NORMAL] or [16:9 AUTO].
(See page 27.)
ENGLISH
ENGLISH
OFF
ENGLISH
ENGLISH
SPANISH
FRENCH
4:3 L.B.
16:9 NORMAL
16:9 AUTO AUTO
4:3 LB
ON
4:3 PS
MP3