Assembly Steps - Tunturi Pure Cross R 10.1 Mode D'emploi

Assembly steps

Assembly step A
• Fit height adjustment pads to the
front stabilizer.
• Fit front stabilizer by using the shown
hardware.
Remark:
First put all screws/ bolts in correct place
before tightening them fully.
Assembly step B
• Fit height adjustment pads to the rear
stabilizer.
• Fit rear stabilizer by using the shown
hardware.
Remark:
First put all screws/ bolts in correct place
before tightening them fully.
6
Assembly step C
•
• Connect the wires from upright tube
and main frame before sliding the
upright tube in position.
Remark:
Do not remove screws from the frame
before siding the upright tube in position.
• Use the enclosed Allen key to tighten
both fastening screws through the
holes in the tube from inside out.
• Tighten the fastening screws by
turning them counter-clockwise.
Remark:
First tighten all 6 bolts hand tight before
tightening them fully. This to avoid miss
alignment
Assembly step D
• Push the metal shaft through the
bracket housing of the left arm.
Attach now the left arm to the front
frame tube by pushing the metal