Table des Matières
Publicité
The electrical diagram must be adapted to the installation to be implemented. For more complex installations than those
presented below, please consult the diagrams book available as a pdf.
Note: The door station can control an electric lock or a motorised gate. To control both, a relay module is required, ref.
9020031.
7.1 Installation with an external "1-button" module and a monitor
1
See diagram
at the end of the document.
7.2 Installation with an external "1-button" module and two monitors
Bus line between the two monitors
2
See diagram
at the end of the document.
Bus line distributed via the electric panel
3
See diagram
at the end of the document.
7.3 Installation with an external "2-button" module and two monitors
4
See diagram
at the end of the document.
7.4 Push button for a remote buzzer
It is possible to connect an independent push button enabling the buzzer on the monitors to ring with a different tune
from that used for calls from an external module.
11
Brightness setting thumb-wheel
16
Contrast setting potentiometer
17
Colour setting potentiometer
12
Buzzer level selector
Conversation
13
thumb-wheel
Note: do not alter the setting of the potentiometer to the le of potentiometer 16 (factory setting).
Copyright © 2016 Somfy SAS. All rights reserved.
7 ELECTRICAL DIAGRAM
9020027
9020027
0
0
230V
230V
+BUS-
+BUS-
N L
230 VAC
50 Hz
8 SETTINGS
Front panel
Perform a communication test with the external module. Turn thumb-
wheel 11 and potentiometers 16 and 17 until the image is displayed
correctly.
Perform a buzzer test, adjust the 3-position selector to the position that
suits the users.
volume
setting
Perform a communication test with the external module. Turn the thumb-
wheel until the voice of the person speaking can be heard clearly.
Back of the front panel
16
17
11
12
13
EN
11
Publicité
Chapitres
Table des Matières
