Subaru H001SAL002 Installation page 9

8
PRE-ARRANGED JUMPER HARNESS CONNECTIONS
1. Locate the vehicle's 4-pin and 2-pin pre-fit
connectors behind the vehicle's fusebox near the
kick panel area. These connectors are secured to
the vehicle wiring using breakaway tape.
(FIGURE W)
2. When the 2-pin pre-fi t connector is located, unplug
and discard the mating wire jumper. (This is used
for the power window interrupt circuit.)
3. Plug the remote engine start pre-arranged jumper
harness 4-pin and 2-pin connectors into the
corresponding pre-fi t connectors. (FIGURE X)
4. Plug the 12-pin pre-arranged harness into the
12-pin white port on the remote engine start ECU
(installed in previous section). (FIGURE X)
5. Plug the 5-pin antenna harness into the 5-pin black
port on the remote engine start ECU (installed in
previous section). (FIGURE X)
6. Using one (1) of the supplied 20cm tie wraps,
bundle and secure any excess pre-arranged jumper
harness to the existing vehicle wiring.
(FIGURE X)
PART NUMBER ISSUE
H001SAL002
FIGURE X
DATE
00 24 Jan 2017
FIGURE W
SUBARU OF AMERICA
9 OF 19