Subaru H001SAL002 Installation page 14

9
IGNITION HARNESS CONNECTIONS, continued
8-PIN IGNITION SWITCH CONNECTIONS, continued
11. Route the remote engine start ignition harness down the steering column along the top of the vehicle's plastic wire
harness shroud. Secure the remote engine start ignition harness to the vehicle's plastic wire harness shroud with one
(1) supplied 39cm tie wrap. (FIGURE FF)
12. Continue to route the remote engine start ignition harness along the vehicle's ignition harness towards the left side of
the dashboard and secure it with three (3) of the supplied 39cm tie wraps. (FIGURE FF)
13. Allow the remote engine start ignition harness to drop down behind the vehicle's fusebox and plug into the bottom
(large) connector on the remote engine start ECU (previously mounted in Section 7). (FIGURE FF)
14. Secure the remote engine start ignition harness and any excess antenna harness to the vehicle wiring using two (2) of
the supplied 39cm tie wraps. (FIGURE FF)
CAUTION: DO NOT SECURE THE REMOTE ENGINE START HARNESS TO ANY YELLOW HARNESSES /
CONNECTORS (AIRBAG SYSTEM) IN THE VEHICLE.
FIGURE FF
PART NUMBER ISSUE
H001SAL002
Plastic Wire Harness Shroud
DATE
00
24 Jan 2017
SUBARU OF AMERICA 14 OF 19