Subaru H001SAL002 Installation page 18

13
SYSTEM POWER-UP
1. After all the connections are complete, re-connect the vehicle's negative battery terminal. Using a 12mm socket/
torque wrench, tighten the 12mm nut to 7.5 Nm +/- 2 Nm (0.76 Kgf-m +/- 0.2 Kgf-m, 5.5 ft-lbs +/- 1.5 ft-lbs).
2. Start the vehicle a minimum of one (1) time using the ignition key prior to activating the remote engine start system.
This is required to allow the vehicle electronic systems to re-synchronize.
3. With the vehicle running via the ignition key, verify that the instrument cluster airbag light turns off. If the airbag light
remains on, refer to the vehicle service information for troubleshooting.
4. With the vehicle running by the ignition key, apply the brake pedal and shift the transmission out of park. Turn off
the engine and confi rm the ignition key cannot be removed from the ignition switch. If it can, confi rm the key lock
solenoid and key chime connectors are fully engaged and the delivery (test) mode fuse is removed, then re-check.
5. Refer to the vehicle Owner's manual for the Power Window Reset Procedure to restore the power window functions.
14
SYSTEM REGISTRATION
NOTE: For registration by DST-i SSM, reference immobilizer registration manual.
SDI SETUP
Plug the SDI
diagnostic plug
into the vehicle's
diagnostic
connector
REGISTRATION
Using the arrows
on the SDI select
PRESS
ENT
"Subaru Vehicle"
SDI screen will display
PRESS
"Smart System : ENT
Otherwise : C"
SDI screen will display
"Reg Remote Cont.
PRESS
Eng Starter
ENT
Yes: ENT / No: C"
PART NUMBER ISSUE
H001SAL002
Insert any ignition
key into the
ignition cylinder
and turn to the
RUN position
Using the arrows
PRESS
on the SDI select
"All Other Model"
SDI screen will display
PRESS
"Confirm IGN ON
C
YES : ENT / NO : C "
Confirm Ignition Sw On
PRESS
Press "Ent"
DATE
00
24 Jan 2017
Press and hold the SDI
"Menu" and "C" buttons
simultaneously for
approximately 5 seconds
to enter stand alone mode
Using the arrows
on the SDI select
ENT
"Imm Regist"
SDI screen will display
"IMMOBILIZER
ENT
Press Ent"
SDI screen will display
"Registering...
ENT
Please Wait"
SUBARU OF AMERICA
Proceed to
"Registration"
The SDI screen
will display
PRESS
"Select Reg Sys"
ENT
Press ENT to
select Immobi Sys
PRESS
ENT
Using the arrows
PRESS
on the SDI select
ENT
"R/C E/G ST Reg"
PRESS
ENT
SDI screen will display
"Remo.con.eng.st
WAIT
regist.success"
Registration
PRESS
ENT Complete
18 OF 19