Subaru H001SAL002 Installation page 8

7
REMOTE START ECU/BRACKET MOUNTING
1. Locate the vehicle's auxiliary relay block bracket mounted to the dashwall
behind the fusebox and to the left of the brake pedal. (FIGURE T)
2. Remove the two (2) 10mm mounting nuts. (FIGURE T)
3. Lift the auxiliary relay block bracket off of the mounting studs.
4. Position the remote engine start ECU bracket onto the mounting studs.
(FIGURE U)
5. Install the relay block bracket back onto the mounting studs on top of the
remote engine start ECU bracket. (FIGURE V)
NOTE: Confi rm the remote engine start ECU bracket is positioned
under the relay block bracket and on top of the dashwall insulation
material.
6. Verify the remote engine start ECU bracket and relay block bracket are
properly seated, then torque the lower 10mm mounting nut, followed by
the upper 10mm mounting nut to 10.8 Nm +/- 2 Nm (1.10 Kgf-m +/- 0.2
Kgf-m, 8 ft-lbs +/- 1.5 ft-lbs).
PART NUMBER ISSUE
H001SAL002
T
FIGURE V
DATE
00
24 Jan 2017
T
SUBARU OF AMERICA
FIGURE T
Mounting Studs
FIGURE U
8 OF 19