Subaru H001SAL002 Installation page 12

9
IGNITION HARNESS CONNECTIONS, continued
8-PIN IGNITION SWITCH CONNECTIONS, continued
4. Using alcohol, clean the large metal bracket thoroughly.
Ensure the bracket is clean and dry. Using four (4)
pieces of the supplied flock tape, wrap the large
metal bracket edges, as shown. Press fi rmly in place.
(FIGURE AA)
NOTE: Ensure the fl ock tape pieces are positioned
properly to prevent the remote engine start ignition
harness from chafing against the large metal
bracket.
5. Using two (2) of the supplied 39cm tie wraps, secure
the remote engine start ignition harness to the vehicle
harness running up the center of the large bracket.
The fi rst tie wrap should secure the harness in front of
the bracket at the new (blue) tape ring. The second tie
wrap should secure the harness behind the bracket at
the new (blue) tape ring. (FIGURE BB)
CAUTION: DO NOT SECURE THE REMOTE ENGINE
START IGNITION HARNESS TO ANY YELLOW HAR-
NESSES/CONNECTORS (AIRBAG SYSTEM) IN THE
VEHICLE.
6. Using a Phillips screwdriver, reinstall the two (2) screws
securing the large metal bracket to the left side of the
steering column. Torque the screws to 4 Nm +/- 1 Nm
(0.41 Kgf-m +/- 0.1Kgf-m, 2.95 ft. lbs. +/- 0.74 ft. lbs.).
(FIGURE Z)
NOTE: Use care to ensure the screws are not over
tightened to prevent damage to the screws.
PART NUMBER ISSUE
H001SAL002
DATE
00
24 Jan 2017
FIGURE AA
FIGURE BB
SUBARU OF AMERICA 12 OF 19