Subaru H001SAL002 Installation page 7

WINDSHIELD MOUNT ANTENNA INSTALLATION -
6
EYESIGHT EQUIPPED VEHICLES, continued
HARNESS ROUTING
1. Plug the 5-pin antenna harness into the previously installed
antenna pod. (FIGURE Q)
2. Route the antenna harness straight up into the headliner,
then across the headliner and down the A-pillar. Tuck
the cable below the driver's side dashboard through the
opening closest to the windshield and allow the harness
to hang loose behind the vehicle's dashboard mounted
fusebox. The antenna harness will be plugged into the
remote engine start control during Section 8. (FIGURE R)
3. Secure the antenna harness to the vehicle wire harness in
the A-pillar in fi ve (5) places using the supplied 20cm tie
wraps. (FIGURE S)
4. Using one of the supplied 20cm tie wraps, secure the
antenna harness to the vehicle wiring behind the fusebox.
5. Re-install the airbag tether clip to the A-pillar panel and
rotate the panel into place.
6. Re-install the A-pillar panel.
PART NUMBER ISSUE
H001SAL002
DATE
00 24 Jan 2017
FIGURE Q
FIGURE R
FIGURE S
SUBARU OF AMERICA
7 OF 19