Subaru H001SAL002 Installation page 19

15
POST INSTALLATION CHECKLIST
1. REMOTE ENGINE START- Ensure the key is removed from the ignition switch, the engine hood, all doors
and trunk are closed. Press the START button two (2) times within three (3) seconds. The vehicle's parking
lights should fl ash and the vehicle's horn should honk one (1) time and then the vehicle should crank and
start. Once started, the transmitter button will fl ash (2) times and the parking lights will turn on and stay on
signifying the vehicle is running. The transmitter button will fl ash one (1) time every fi ve (5) seconds signifying
the vehicle is still running.
2. SHUT DOWN WITH DOOR OPEN - While the vehicle is running by the remote engine start, wait at least
fi ve (5) seconds and then confi rm that all functions (lock, unlock & trunk, but not panic) operate properly on
the FACTORY transmitter. Once FACTORY transmitter functionality is confi rmed, press the UNLOCK button
on FACTORY transmitter and open any vehicle door. The remote engine start should shut down and the
transmitter button should fl ash three (3) times indicating the system has shut down.
3. ACTIVATION WITH DOOR OPEN - Ensure the key is removed from the ignition switch and the engine hood
and trunk are closed. Open the driver's door, press the START button two (2) times within three (3) seconds.
The vehicle's parking lights should fl ash and vehicle's horn should honk six (6) times. The vehicle should
not start with any door or trunk opened.
4. BRAKE PEDAL SAFETY - While sitting in the vehicle with the engine hood, all doors and trunk closed,
activate the remote engine start and press the brake pedal. The vehicle should shut off.
5. KEY-IN-SENSE - While sitting in the vehicle with the engine hood, all doors and trunk closed, insert the
ignition key into the ignition switch, but keep it in the OFF position. Activate the remote engine start. The
vehicle's parking lights should fl ash and the vehicle's horn should honk two (2) times. The vehicle should
not start since the key is in the ignition switch.
6. HOOD SAFETY SWITCH - Open the engine hood and activate the remote engine start. The vehicle's parking
lights should fl ash and the vehicle's horn should honk two (2) times. The vehicle should not start since the
hood safety switch is activated.
7. HEATER / AC FUNCTION - Using the ignition key, turn the ignition to the ON position. Preset the vehicle's
heater or air conditioning to the ON position. Turn the ignition OFF and remove the ignition key. Activate
the remote engine start and verify that the heater or air conditioning turns on to the preset setting for manual
climate controlled vehicles or turns to the "Full Auto" setting for electronic climate control vehicles.
8. 15 MINUTE RUN TIME - Activate the remote engine start and allow the system to run for the 15 minute
preset run time. The remote engine start should shut down after 15 minutes (+/- 10 seconds).
9. TRANSMITTER FUNCTIONALITY VERIFICATION - Activate the remote engine start using both of the
supplied single button transmitters.
10. With the vehicle running by the ignition key, apply the brake pedal and shift the transmission out of park.
Turn OFF the engine and confi rm the ignition key cannot be removed from the ignition switch. If it can,
confi rm the key lock solenoid and key chime connectors are fully engaged and the delivery (test) mode
fuse is removed, then re-check.
PART NUMBER ISSUE
H001SAL002
DATE
00 24 Jan 2017
SUBARU OF AMERICA
19 OF 19
4280714 Rev - 1/24/17