Subaru H001SAL002 Installation page 5

WINDSHIELD MOUNT ANTENNA INSTALLATION -
5
NON EYESIGHT EQUIPPED VEHICLES, continued
3. Route the antenna harness across the headliner and
down the A-pillar. Tuck the cable below the driver's side
dashboard through the opening closest to the windshield
and allow the harness to hang loose behind the vehicle's
dashboard mounted fusebox. (FIGURE L) The antenna
harness will be plugged into the remote engine start control
module during Section 8.
4. Secure the antenna harness to the vehicle wire harness in
the A-pillar in fi ve (5) places using the supplied 20cm tie
wraps. (FIGURE M)
5. Using one of the supplied 20cm tie wraps, secure the
antenna harness to the vehicle wiring behind the fusebox.
6. Re-install the airbag tether clip to the A-pillar panel and
rotate the panel into place.
7. Re-install the A-pillar panel.
PROCEED TO SECTION 7
PART NUMBER ISSUE
H001SAL002
DATE
00 24 Jan 2017
FIGURE L
FIGURE M
SUBARU OF AMERICA
5 OF 19