Subaru H001SAL002 Installation page 10

9
IGNITION HARNESS CONNECTIONS
8-PIN IGNITION SWITCH CONNECTIONS - REVISED SECURING LOCATIONS
If the RES Kit is equipped with the original Rev - Ignition Harness (White tape rings), a minor modifi cation is
required before routing to identify the new tie wrap securing locations.
1. Measure 30mm from the edge of White Tape Ring #1 and mark the harness by wrapping a new piece of
electrical tape around the harness, as shown below.
2. Measure 30mm from the male ignition connector harness break out and mark the harness by wrapping a new
piece of electrical tape around the harness, as shown below.
3. The two (2) new securing locations, marked with electrical tape, will be used during Section 9 (Figure BB). The
white tape rings are no longer used.
NOTE: If the RES Kit is equipped with the new Rev A Ignition Harness (Blue tape rings), no modifi cations
are necessary. Proceed with the ignition harness installation on Page 11.
PART NUMBER ISSUE
H001SAL002
DATE
00
24 Jan 2017
White Tape
White Tape
Ring #1
Ring #2
30mm
New (Blue)
Tape Rings
SUBARU OF AMERICA
30mm
10 OF 19