Subaru H001SAL002 Installation page 17

11
UNDER HOOD WARNING LABEL MOUNTING
1. Using alcohol, clean the top of the air intake plenum,
near the radiator core support.
2. Remove the adhesive backing from the under hood
warning label and secure it to the top of the air intake
plenum, as shown. (FIGURE NN)
12
PANEL RE-ASSEMBLY
1. Re-install the steering column shroud and secure in place with two (2) Phillips screws.
2. Re-install the metal knee bolster and torque the two (2) 10mm bolts to 7.5 Nm +/- 2 Nm (0.76 Kgf-m +/- 0.2 Kgf-m,
5.5 ft-lbs +/- 1.5 ft-lbs).
3. Plug in any previously removed connectors and re-install the driver's lower dashboard panel by engaging four (4)
pressure clips.
4. Re-install the under dashboard fi nisher panel by engaging three (3) pressure clips.
5. Re-install the one (1) Phillips screw on the left side of the dashboard that secures the driver's lower dashboard panel
in place.
6. Re-install the left side dashboard panel by engaging fi ve (5) pressure clips.
7. At the end of the installation, insert the Quick Reference Cards into the Owner's Information Kit.
PART NUMBER ISSUE
H001SAL002
DATE
00 24 Jan 2017
FIGURE NN
SUBARU OF AMERICA
17 OF 19