Subaru H001SAL002 Installation page 4

WINDSHIELD MOUNT ANTENNA INSTALLATION -
5
NON EYESIGHT EQUIPPED VEHICLES
IMPORTANT! THIS SECTION ONLY APPLIES TO VEHICLES WITHOUT THE EYESIGHT SYSTEM.
FOR VEHICLES EQUIPPED WITH THE EYESIGHT SYSTEM, DISREGARD THIS SECTION AND
PROCEED TO SECTION 6
A-PILLAR PANEL REMOVAL
1. Remove the driver's side A-pillar panel by releasing the
two (2) body clips along with the lower clips where the
A-pillar panel meets the dashboard. (FIGURE H)
2. Rotate the A-pillar panel away from the dashboard and
release the airbag tether clip from the top of the A-pillar
panel. (FIGURE I)
CAUTION! Use care when performing this step to
avoid damage to the curtain airbag. If the airbag is
damaged, it must be replaced.
3. Inspect the white protective (non-woven fabric) of the
curtain airbag. If the fabric is damaged, the curtain airbag
assembly must be replaced.
ANTENNA POD MOUNTING / HARNESS ROUTING
1. Plug the 5-pin connector from the antenna harness into the
5-pin port on the antenna pod. (FIGURE J)
2. Using alcohol, clean the glass surface near the antenna
mounting area. Remove the adhesive backing on the
antenna pod and apply the antenna to the windshield. The
base of the antenna pod (harness connection end) should
line up to the area of the windshield where the solid black
fi lm and dotted black fi lm meet and 25mm (1") left of the
windshield center mark. (FIGURE K)
PART NUMBER ISSUE
H001SAL002
.
DATE
00
24 Jan 2017
FIGURE H
FIGURE J
Clean mounting
area with alcohol
FIGURE K
SUBARU OF AMERICA
FIGURE I
4 OF 19