Subaru H001SAL002 Installation page 16

10
HOOD SAFETY SWITCH MOUNTING, continued
6. Using the supplied foam tape, wrap the vehicle's hood
safety switch wiring starting where it meets the main
vehicle wiring near the ABS Unit. (FIGURE KK)
7. Securely mount (snap-in) the supplied hood safety switch
into the bracket and plug the vehicle's pre-fi t 2-pin female
hood switch connector to the base of the hood safety
switch. (FIGURE LL)
8. Install the supplied adhesive backed cable clip to the
angled vehicle frame rail approximately 6cm to the left of
the hood safety switch mounting bolt. Coil any excess
hood safety switch wiring and secure with the cable clip.
(FIGURE LL)
9. 3.6L (6 Cylinder) vehicles - Using one (1) of the supplied
20cm tie wraps, secure the hood switch harness to the
factory wiring. (FIGURE MM)
PART NUMBER ISSUE
H001SAL002
DATE
00
24 Jan 2017
Foam Tape
FIGURE KK
FIGURE LL
3.6L (6 Cylinder) Vehicles Only
FIGURE MM
SUBARU OF AMERICA 16 OF 19