12. TROUBLESHOOTING
PROBLEM
1. Failure to start
2. Power loss.
3. The engine runs
at minimum or
operates irregularly
4. Excessive vibrations
5. Losses or slowing down
during snow ejection
6. The traction is
inoperative
If problems persist after implementing the solution, contact your Dealer.
PROBABLE CAUSE
Ignition key not inserted.
No fuel
Disengaged choke
Primer not pressed
Engine flooded
Disconnected spark plug wire
Spark plug damaged
Old fuel
Water in the fuel
Too much snow ejected
Fuel tank plug covered with ice or snow. Remove the ice or snow on top
Silencer dirty or clogged
The choke is engaged
Old fuel
Water in the fuel
The carburettor must be replaced
Loose parts or auger or rotor damaged. Tighten all fixing devices.
Handle positioned incorrectly.
Clogged discharge chute.
Jammed auger.
The traction operation control
cable is adjusted incorrectly.
Insert the ignition key
Fill the tank with clean and pure fuel.
Engage the choke.
Press the primer
Wait a few minutes before starting. Do not
press the primer and disengage the choke.
Contact your Authorised Service Centre.
Contact your Authorised Service Centre.
Contact your Authorised Service Centre.
Contact your Authorised Service Centre.
Reduce the speed
or around the tank plug.
Contact your Authorised Service Centre.
Disengage the choke.
Contact your Authorised Service Centre.
Contact your Authorised Service Centre.
Contact your Authorised Service Centre
Replace the damaged parts at an
Authorised Service Centre.
Make sure that the handle is
fastened in its position.
Clean the discharge chute.
Remove any residues or foreign
objects from the auger.
Contact your Authorised Service Centre.
EN - 15
SOLUTION