socomec DIRIS Am Notice D'utilisation page 39

4 PROGRAMMING THE VOLTAGE TRANSFORMER (VT)
NB: As a default setting, the network is configured for low voltage operation without a voltage transformer (NO). If you
do not want this, press
KEYS INSTRUCTION
Press once
Press once
Press once
5 PROGRAMMING THE VOLTAGE TRANSFORMER (VT)
NB: The default ratio setting is 100/100. To change it, proceed as follows:
KEYS INSTRUCTION
Press once
Press to decrement or
Press once to confirm value
Press once to pass to programming (TIME 3I).
NB: The 6 digits correspond to the primary value (400 000V maximum) and the last 3 digits to the secondary value
(60, 100, 110, 173 and 190V)
6 PROGRAMMING INTEGRATION TIME (TIME 3I)
NB: The time default setting is 15 minutes (3I 15). If you want this value, press
tion time programming line (TIME P/Q/S) . If not, proceed as follows:
KEYS INSTRUCTION
Press once
40
. You will pass to the time integration programming (TIME 3I) .If not, proceed as follows:
to increment the selected digit value.
DISPLAY
DISPLAY
. You will pass to the power integra-
DISPLAY
COMMENT
to display flashing NO
to programm
the use of a VT
Confirm a VT. Press
on to pass to VT
programming
COMMENT
Press as many times
as necessary to move
to the right, or press
to move to the left.
COMMENT
to display flashing
15 minutes
SOCOMEC - Ref. : 875 508A