socomec DIRIS Am Notice D'utilisation page 37

PROGRAMMING
1 HOW TO ACCESS PROGRAMMING MODE
KEYS INSTRUCTION
Press for 3 seconds,
PROG
then release.
NB: Enter the access code '100' to access programming, and proceed as follows:
Press once
Press once
2 PROGRAMMING THE NETWORK
NB: As a default setting, the network is configured as 4NBL (4 unbalanced wires with 3 CTs). If you want this setting,
press on . You will pass to the CT programming line. If not, proceed as follows:
KEYS INSTRUCTION
Press once
Press once
Press once
38
DISPLAY
DISPLAY
or
COMMENT
Confirm with
the code and pass to
network programming
(NETWORK)
COMMENT
To display flashing 4NBL
Press again for:
2BL
3BL
3NBL
4BL
Press again for:
3NBL
3BL
2BL
1BL
SOCOMEC - Ref. : 875 508A