Implements - Grillo FM13.09 Emploi Et Entretien

Translation of the original instructions
TOWING OF THE MACHINE WITH SWITCHED OFF ENGINE
Attention! To move the machine with switched off engine unscrew of two turns the screw on the hydrostatic pump
(fig. 35); pay attention because doing so the efficiency of the self-braking device is cancelled.
Tow the machine at very low speed and only on small distances, maximum 100 metres, to avoid hydraulic
pump or engine seizing.
STORAGE AND LACK OF USE FOR LONG PERIODS
Store the machine in a dry environment, sheltered from the elements and, if possible, covered up.
If the mower will not be used for a long period (more than one month), disconnect the red battery lead and follow the
directions given in the engine manual; in addition grease all the joints.
Check regularly that the battery voltage has not dropped below 12.5 Volts and if it does so, recharge it.

IMPLEMENTS

LIFTING HOOKS AND TRANSPORT
The lifting hooks (fig. 36) location permits that the machine with the mounted cutting deck is perfectly balanced if it
must be lifted up with a crane. Check the machine's weight on the plate and use suitable equipment (ramps, crane,
etc.). If the machine is carried with a camion or with a towed trailer, put the cutting deck in a low position, engage
the parking brake and tie it to the mean of transport through ropes, cables, or chains.
BODY DISCHARGE LEVER
To check the engine or to offload material from the body, use the lever (fig. 26). It is a rear tipper body.
15