Maintaining The Base Adjustment - Invacare I-Lift TM Manuel D'utilisation

1. Remove the rubber cover A from the boom B.
2. Remove the clip C and clevis pin D securing the hanger bar
pin E to the boom.
3. Reverse STEPS 1- 2 to install the new hanger bar.

8.14 Maintaining the Base Adjustment

The base A adjustment should not require any attention other than
adjusting the linkage rods.
1171892-B
Damage to the lift may occur.
– The leg actuator must be in the fully closed position
before adjusting the linkage rods.
1. Close the legs all the way. Refer to Closing/Opening Manual
Legs, page 19 or Closing/Opening Electric Legs, page 20.
Check the squareness of the legs B when in the closed position.
2.
Place a square C on the inside of the legs and base to determine
3.
the 90° alignment D.
Adjust the linkage rods E until 90° alignment is achieved.
4.
Damage to the lift may occur.
– DO NOT adjust the linkage rods so the legs are at less
than 90° alignment.
Maintenance
47