Adjustment Of The Braking Effect - Invacare DOLOMITE Série Manuel D'utilisation

For optimum performance insure that handles are in the allowed
adjustment area at all times. The arrow, which is placed on the tubes
on the inside of the rollator, pointing on the thin inner vertical line
indicates maximum allowed outer handle position.

3.4 Adjustment of the Braking effect

For desirable braking strength, adjust the brake wire with suitable tools
(not included). The wire can be adjusted in two places - above under
the brake handle or below above the brake clamp. The brake handle
must be in neutral position.
Loosen the locking nut and turn the hexagon nipple counter clockwise
in order to increase the braking effect. The distance between the
brake clamp and the wheel should be 2 mm. Tighten the locking nut
again to fixate the new adjstment. Check the braking effect by engaging
the parking brake and check that the wheel can´t rotate.
WARNING
Make sure to tighten the lock nuts after adjustment.
23
Alt.