Special Safety Instructions - Phoenix Mecano RK Rose+Krieger LZ 70 Notice D'assemblage

5.2 Special safety instructions

•
All work with the electric cylinder may only be carried out in accordance with these instructi-
ons.
•
The device may only be opened by authorized specialist personnel. If there is a fault in the
electric cylinder, we recommend contacting the manufacturer and / or sending the electric
cylinder to be repaired.
•
Unauthorised modifications or changes to the electric cylinder are not permitted for safety
reasons.
•
The performance data for this electric cylinder specified by RK Rose+Krieger GmbH must not
be exceeded.
•
The type plate must remain legible. It must be possible to identify the ratings data effortlessly at any
time.
•
Safety-relevant hazard symbols identify danger areas on the product.
•
Safety-relevant devices must be inspected at regular intervals, but at least once a year, for pro-
per function, damage and completeness.
•
With an overhead installation of the electric cylinder, fixed loads must be secured against fal-
ling down.
The danger area underneath the application must be marked in the documentation of the end
product.
•
An electric drive or electrically driven components may only be connected to this electric cyl-
inder by the appropriate technical staff, in observance of the local connection conditions and
regulations (e.g. DIN, VDE).
•
Permanently monitoring the motor current. By monitoring the motor current, faults can be
detected immediately and hazards originating from the system can be avoided.
•
Wear the necessary personal protective equipment (PPE) at all times during work.
•
If a mains lead and / or feed line is damaged, the electric cylinder is to be taken out of service
immediately.
5. Safety
41