Phoenix Mecano RK Rose+Krieger LZ 70 Notice D'assemblage page 36

1. Declaration of Incorporation
Sources for the harmonised standards according to Article 7, Paragraph 2
EN ISO 12-100:2010-11:
Places where the applied other technical standards and specifications were found:
ÖNORM EN ISO 13857:2008-08-01
The manufacturer or the person authorised are obliged to hand over the special documents for
the partially completed machine to the national authorities on reasoned request. This transfer is
carried out in electronic format.
The commercial protective rights remain unaffected by this.
Important note! The partially completed machine must only be put into operation once, if re-
quired, it has been determined that the machine in which the partially completed machine is to be
installed complies with the regulations of this guideline.
Minden / 28.07.2014
Place / Date
Minden / 28.07.2014
Place / Date
36
Safety of machinery – General principles for design – Risk assessment and
risk reduction.
Safety of machinery – Safety distances to prevent hazard zones being
reached by upper and lower limbs (ISO 13857:2008)
Signature
Signature
Technical Manager
Signatory information
Managing Director
Signatory information