CAUTION
• Hazards or unsafe practices that may result in
minor personal injury or property damage.
• Perform the drainage/piping work securely according
to the installation manual. If not, water could drop
from the unit and household goods could get wet and
damaged.
• Fasten a flare nut with a torque wrench as specified
in this installation manual. When fastened too tight,
a flare nut may break after a long period of time and
cause refrigerant leakage.
• Wear thick gloves during the installation process. If
not, personal injury may occur due to the Air to water
heat pump parts.
• Be careful not to touch the outdoor unit inlet or
aluminum pins. You may get personal injury.
• Do not install the outdoor unit in a place where
animals could live. If an animal get contact with the
electric parts, damage or fire may occur. In addition
ask the customer to maintain a clean installation place
around it.
• After completing the installation run the trial
operation. If no error occurs, explain to the customer
how to use and clean the Air to water heat pump
according to the user's manual. In addition give the
installation manual and the user's manual to the
customer.
• Check the unit for damage that may have taken
place during transportation and do not install or use
damaged equipment.
• All of the manufacturing and packaging material
used for your new appliance are compatible with the
environment and can be recycled.
• Dispose of the packaging material in accordance with
the local requirements.
• This product is an air conditioning system and contains
a coolant that must be recovered and disposed of
in an appropriate way by qualified personnel. At the
end of the life cycle, take it to a proper recycling or
disposal center or return it to the dealer so that it can
be disposed correctly.
• Do not connect the heater to the outdoor unit
and do not install remodeled duct as you please.
‐ The capacity of the Air to water heat pump
may reduce, electric shock or fire may occur
and it has a chance of occurrence of and
accident like electric shock or fire.
• Make sure that the condensed water dripping
from the drain hose runs out properly and
insulate the drain pipe so that frost does not
generate.
‐ Household goods may get wet if the drain
pipe is not properly installed.
• Install the power cable and communication cable
of the indoor and outdoor unit at least 1.5m away
from electric appliances.
‐ Noise may hear depending on the electric
wave though the cables are installed away
from electric appliances.
• Install the indoor unit away from lighting
apparatus using the ballast.
‐ If you use the wireless Remote controller, it may
not operate normally.
5
English