Table des Matières
Publicité
Disassembling the Leg Base and Wood
Palette / Fastening the Anchor Bolt
1 Disassemble the three screws (with an electric
driver) which fixes wood palette.
2 Disassemble the bottom-left screw with monkey
spanner.
• Do not remove guard fan.
Monkey spanner
3 After removing the wood palette, move the outdoor
unit to the installation place.
4 Fasten the bottom-left screw with monkey spanner
first, and then fasten the other three anchor bolts.
Screw
Wood palette
Installing the Outdoor Unit
CAUTION
• Do not install the outdoor unit on a wooden
pallet palette.
• Fix the outdoor unit completely to the base fix
the outdoor unit with anchor bolts.
• The manufacturer is not responsible for the
damage occurred by not keeping standard of the
installation.
• Install the outdoor unit higher than 150mm from the
base surface and install the drain hole to connect the
pipe to the drainage.
• If front fan outdoor unit is installed where average
snow fall is 150mm or more, a duct should be fitted to
the unit.
• The concrete foundation should be 1.5 times larger
than bottom of the outdoor unit.
• When heating, condensed water may be generated.
Pay attention to waterproof and drainage of the
concrete foundation where the outdoor unit is
installed. (An ice patch may form on the base surface
in winter.)
• Install a square pad(t=20mm or more) to prevent
vibration of the outdoor unit delivering to the base
surface when installing the concrete for the outdoor
unit.
Drain hole
< When installing on the ground >
Install the outdoor unit
horizontally on the ground
< When installing on the roof >
※ Base mount construction
(Unit : mm)
150 or more
150 or more
English
13
Publicité
Table des Matières
