Table des Matières
Publicité
How to connect your extended power cables
1 Prepare the following tools.
Tools
Spec
Shape
2 As shown in the figure, peel off the shields from the rubber and wire of
the power cable.
– Peel off 20 mm of cable shields from the pre-installed tube.
CAUTION
• For information about the power cable specifications for indoor and
outdoor units, refer to the installation manual.
• After peeling off cable wires from the pre-installed tube, insert a
contraction tube.
3 Insert both sides of core wire of the power cable into the connection sleeve.
• Method 1
Push the core wire into the sleeve from both sides.
• Method 2
Twist the wire cores together and push it into the sleeve.
4 Using a crimping tool, compress the two points and flip it over and compress another two points in the same
location.
– The compression dimension should be 8.0.
– After compressing it, pull both sides of the wire to make sure it is firmly pressed.
48
English
Crimping pliers
Connection sleeve (mm)
MH-14
20xØ6.5 (HxOD)
• Method 1
Compression
dimension
Insulation tape
Width 19mm
Power cable
• Method 2
Compress it 4 times.
5 mm
Contraction tube (mm)
70xØ8.0 (LxOD)
20
20
20
60
120
180
(Unit: mm)
20
Pre-installed tube for the power cable
Connection sleeve
Connection sleeve
Compress it 4 times.
5 mm
Publicité
Table des Matières
