Publicité
Les langues disponibles
Les langues disponibles
V 4.0
POWER CORD
1.
Insert the power cord plug directly to the power supply whenever possible.
Use extension cords or surge protectors only when the tool's power cord
cannot reach a power supply from the work area.
2.
Do not operate this tool if the power cord is frayed or damaged as
an electric shock or surge may occur, resulting in personal injury or
property damage.
a.
Inspect the tool's power cord for cracks, fraying or other faults in the
insulation or plug before each use.
b.
Discontinue use if a power cord feels more than comfortably warm
while operating the tool.
c.
Have the power cord replaced by a qualified service technician.
3.
Keep all connections dry and off the ground to reduce the risk of electric
shock. Do not touch plug with wet hands.
4.
Prevent damage to the power cord by observing the following:
a.
Do not pull on the cord to disconnect the plug from an outlet.
b.
Keep cord away from heat, oil, sharp edges or moving parts.
5.
Do not allow people, mobile equipment or vehicles to pass over
unprotected power cords.
a.
Position power cords away from traffic areas.
b.
Place cords in reinforced conduits.
c.
Place planks on either side of the power cord to create a protective trench.
ELECTROMAGNETIC FIELDS FOR DEVICES
WARNING! Shut off the electrical tool or device and move away if you feel
faint, dizzy, nausea or shocks. Seek medical attention.
Electromagnetic Fields (EMF) can interfere with electronic devices such as
pacemakers. Anyone with a pacemaker should consult with their doctor before
working with or near a tool that generates an EMF. The following steps can
minimize the effects of electromagnetic fields.
1.
Keep the power source and any power cables as far away from the user as
practical. A minimum of 24 in. is recommended.
Visit www.princessauto.com for more information
20 in. Floor-Mount Drill Press
8654402
9
Publicité
