Power Fist 8654402 Manuel D'utilisateur page 17

V 4.0
DRILL BIT INSTALLATION
CAUTION! Wear heavy-duty work gloves to provide protection when inserting
and removing drill bits. Drill bits become very hot during use. Do not remove
a drill bit until it has cooled.
1. Insert the drill bit into the jaws of the chuck approximately 1 in., ensuring
that the jaws do not touch the flutes of the drill bit.
2. Before tightening the chuck, ensure that the drill bit is centered within the jaws.
3. Tighten the chuck securely with the included chuck key.
CUTTING OIL DRIP SYSTEM
1. Remove the upper Oil Bottle from the Oil Bottle Clips and unscrew the Cap.
2. Make sure that the Oil Pipe valve is closed. Fill the Bottle with your
lubricant of choice.
3. Screw the Cap onto the Bottle and snap the Bottle back into the Clips.
4. Open the Oil Pipe valve and adjust the Pipe so the oil drips onto the cutting
area.
5. The used oil will collect in the Oil Bottle attached to the underside of the
Work Table.
a. Before the Bottle is full, dispose of the used oil in accordance with
local regulations.
Visit www.princessauto.com for more information
20 in. Floor-Mount Drill Press 8654402
Chart 1
17