Publicité
Les langues disponibles
Les langues disponibles
8654402
GENERAL OPERATING INSTRUCTIONS
WARNING! If the drill bit grabs and spins the workpiece, do not attempt to
stop the spinning with your hands, as it can cause an impact injury. Step
back and turn the drill press off. Wait for the spindle to stop turning before
dislodging the workpiece.
1.
Check that the drilling depth will not allow the bit to touch the table. This
can damage the drill bit.
2.
Place the workpiece on the table. Rotate the feed handles to bring the drill
bit down to the wood. Once the workpiece is in the correct position, clamp
it to the table.
a.
If drilling a hole through the entire workpiece, place a scrap piece of
wood beneath the workpiece before positioning and clamping. This will
prevent the underside from splintering as the drill bit breaks through.
3
An irregularly shaped workpiece may not lay flat on the table. Block and
clamp it securely as any tilting, twisting or shifting will create a rough drill
hole and may damage the drill bit or drill press.
4.
Turn the drill press on.
5.
Pull down on the feed handle and slowly drill a hole into the workpiece.
6.
Once the desired depth is reached, slowly push the feed handle up until the
drill bit clears the workpiece.
7.
Turn the drill off. Remove or reposition the workpiece, once the drill bit
stops rotating.
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
a.
Examine belt for cracks, tears in the backing and other damage.
Replace damaged belts by following the instructions to install and
tension under Operation - Changing Drill Speed.
3.
Follow instructions for lubricating and changing accessories.
18
20 in. Floor-Mount Drill Press
For technical questions call 1-800-665-8685
V 4.0
Publicité
