Publicité
Les langues disponibles
Les langues disponibles
V 4.0
j.
Screw the Table Support Lock Handle (#18) into the Table Support but
do not tighten it all the way. Once this is done, turn the Crank, testing
to ensure that the Table Support easily travels up and down the full
length of the Rack without binding and that the assembly and the
Rack rotate freely all the way around the Column without binding.
3.
Head to Column.
a.
Unscrew the Set Screws if they protrude into the column support until
they are out of the way, before installing the Head Assembly.
b.
Raise the Head assembly and locate it on top of the Column. Have
another person assist with this step.
c.
Align the Head assembly with the Base and firmly secure it with the
Set Screws.
d.
Screw the three Spindle Feed Handle Bars (#93) firmly into the
Spindle Feed Handle Seat (#94).
4.
Installing the Chuck.
a.
Thoroughly clean the Arbor (#32) and the tapered hole in the Chuck
(#31) of all dirt, grease, oil and protective coatings. Make sure all
parts are thoroughly clean, dry and burr free.
b.
Loosen the Arm Locking Handle (#18) and slide the Table up the
Column to within 6 in. of the Arbor. Tighten the Arm Locking Handle.
c.
Open the jaws of the Chuck to their maximum, using the supplied Chuck Key.
d.
Slide the Chuck onto the Arbor nose as far as it will go.
e.
Open the jaws of the Chuck to their maximum, using the supplied
Chuck Key.
f.
Place a piece of scrap wood on the table to protect the Chuck nose.
g.
Using the Spindle Feed Handles, lower the Spindle and press the
Chuck nose hard against the scrap wood on the table until the Chuck
is forced into a solid fit. The Chuck is pressure fitted.
5.
Installing the Cutting Oil System
a.
Attach the two Oil Bottle Clips (#75) to the tapped holes in the left side
of the head, using four Socket Head Cap Screws (#73) and four Flat
Washers (#74).
Visit www.princessauto.com for more information
20 in. Floor-Mount Drill Press
8654402
13
Publicité
