Publicité
Les langues disponibles
Les langues disponibles
V 4.0
OPERATION
TOOL SET UP
WARNING! To prevent serious injury from accidental operation. Turn the
Power Switch of the tool off and unplug the tool from its electrical outlet
before performing any procedure in this section.
TABLE ADJUSTMENT
The Table is capable of moving in four directions.
1.
Raise or lower the Table by loosening the Table Support Locking Handle
(Fig. 5-1) and turning the Table Crank (Fig. 5-2): clockwise to raise the
Table and counterclockwise to lower the Table.
2.
Swivel the Table around the column by loosening
the Table Support Locking Handle. The table
assembly, arm and rack (Fig. 5-3), move as one
around the column.
3.
Tilt the table by loosening the Bolt (Fig. 5-4) and
tilting the Table to the required angle. A scale
(Fig. 5-5) is provided on the arm to assist in
setting the required angle. For all normal
operations the Table angle should be set at 0°.
To ensure that the drill is entirely perpendicular
to the table. Insert a piece of straight round bar
in the Chuck, place a square on the Table and
raise the table to bring the square up to the round bar. Adjust the Table tilt
if necessary so that the Table is correctly aligned.
4.
Spin the Table about its axis by loosening the Table Locking Handle (Fig. 5-6).
If The Table Support Is Too Tight
•
Slightly loosen the Table Support Lock Handle and loosen the Collar set
screw.
•
Adjust the Collar slightly to provide a greater working clearance between
the Rack and the Collar.
•
Tighten the Collar set screw and test the Table Support's movement again.
Visit www.princessauto.com for more information
20 in. Floor-Mount Drill Press
8654402
Fig. 5
15
Publicité
