Publicité
Les langues disponibles
Les langues disponibles
8654402
b.
Thread the Oil Pipe (#53) into the bottom of one of the Oil Bottles
(#28), screw an Oil Bottle Cap (#25) onto the Bottle and snap the
Bottle into the Oil Bottle Clips.
c.
Assemble the Oil Bottle Top. Insert the
Hollow Connecting Bolt (#27) through
Sealing Gasket A (#26), then through the
bottom of the Oil Bottle Cap (#25). Place
Sealing Gasket B (#24) onto the
protruding hollow connecting bolt (Fig. 3).
d.
Screw the Bottle Cap assembly into the threaded hole in the underside
of the Work Table. Tighten the Hollow Connecting Bolt enough to
compress the Sealing Gaskets, preventing oil leaks.
e.
Screw the remaining Oil Bottle into the Bottle Cap assembly
underneath the Work Table.
5.
Attaching the Pulley Cover Knob
a.
Slide the Pulley Cover Knob (#124) into the hole in the front of the
Pulley Cover.
b.
Screw the Pan-Head Screw (#125) into the knob from the inside of
the Pulley Cover.
6.
Installing the Drive Belts
a.
Undo the Belt Tension Locking Knobs (#84) on both sides of the
Head. Turn the Belt Tension Lever (#96) clockwise to bring the Motor
Pulley (#107) towards the Spindle Pulley (#44). This will allow the
Belts to be easily slipped over the Pulleys.
b.
Consult the chart inside the pulley cover and install the Belts (#47 and
#116) in the positions corresponding to the required spindle/drill speed.
c.
Turn the Belt Tension Lever counterclockwise so that tension is applied
to the belts. Tension is correct when the
belts deflect by approximately 1/2 in. at
their centers of run when using
reasonable thumb pressure (Fig. 4).
d.
Use the Belt Tension Locking Knobs to
lock the Motor Pulley in this position.
14
20 in. Floor-Mount Drill Press
For technical questions call 1-800-665-8685
V 4.0
Fig. 3
Fig. 4
Publicité
